Installation of the lift
1.
Prepare AC power supply of 110V/220V/240V ready
2.
Use 4pcs M8 down holding bolt to fix the lift firm to the concrete roof of the building.
Concrete roof
Ceiling
3.
Open the ceiling 3CM larger each side than size of this projector lift’s chassis.
4.
Connect the lift with AC power supply
5.
Adjust the motor to make the highest and lowest position of the lift fit the height of the ceiling
and the ideal working position of the lift
Method: Through the Red hole, turning the regulator clockwise to increased uplink,
counterclockwise to reduce the uplink. Through the white hole, tuning clockwise to increase
downlink, counterclockwise to reduce the downlink.
6.
Assemble projector brackets and the projector as is shown:
Projector bracket
Projector
7.
Easy way of adjustment of the lift drop: Lift drop can be adjusted by remote controller: Press
“DOWN” button of the remote, the lift will going down. When the lift reaches the requested
position, press two buttons (“STOP”, “DOWN”) at the same time, and hold for a few seconds.
The remote can memorize this position. Press and hold “UP” and “DOWN” at the same
time, The lift will clear it’s memory. The lift will goes down to it’s maximum drop.
Summary of Contents for CAELOS 200
Page 3: ...reflecta gmbh Junghansring 60 72108 Rottenburg Germany ...
Page 4: ......
