www.reer.it
8541198 - Rev.0
– 27/09/2017
8/12
MOUNTING WITH FMC-CB/FMC-CBL STAND BOTTOM
Mount the FMC-CB/FMC-CBL stand bottom on the floor.
Please note: For a correct alignment, please verify that the stand bottom upper surface is even and horizontal (using
a circular spirit level). To operate the regulation, act on the three hexagonal nuts (B) until the perfect levelness is
reached. (MAXIMUM ADJUSTMENT: 10mm). If the ground roughness is over 10mm, flush it adequately.
Loosen the three allen screws and remove the washers.
Figure 12
Place the column base plate on the FMC-CB/FMC-CBL stand bottom (Figure 13).
Fix the column tightening the three allen screws and the washers.
Figure 13
(B)
