34
e) Setting up the transmitter and vehicle
If you have not already done so, insert the batteries into the transmitter (see Section 8. b). Charge the drive
battery (see Section 8. c) and connect it to the vehicle (see Section 8. d).
Please note that the transmitter is automatically programmed to the vehicle with this model.
• On the transmitter, release the engine lever (
5
) so that it is in the centre position
(neutral position). In addition, release the steering wheel (
1
) for the steering
function.
• Switch the transmitter and the vehicle off (move the switch to ‘
OFF
’). The on/off
switch on the vehicle is located on the bottom next to the battery compartment,
see arrow in the figure to the right (
A
).
• Switch the vehicle on (move the switch to ‘
ON
’).
•
A red LED under the camera starts to flash.
• Switch the transmitter on (
B
) (move the switch to ‘
ON
’). The red LED indicator
(
3
) flickers briefly and then goes out again.
The vehicle is now ready for use and can be controlled with the transmitter
(see next section).
Alternatively, you can also switch the transmitter on before switching
the vehicle on.
When the transmitter is switched on, the LED indicator (
3
) on the trans-
mitter starts to flash rapidly. The vehicle must be switched on while
the LED on the transmitter is flashing. Otherwise, the vehicle will not
respond to the transmitter. If necessary, repeat the above steps.
A
B
