24
13. Maintenance and Care
Clean the exterior of the model and the remote control only with a soft, dry cloth or brush. Never use abrasive cleaning
agents or chemical solutions as these could damage the surfaces of the casings.
The propellers must move smoothly and the motor shafts must neither be bent nor have any play in their bearings.
Propellers that are torn or where small parts have broken off must always be replaced.
Replacing the propellers:
The propellers (1) are only pushed onto the motor shafts
(2) and can be gently pushed off of the shaft.
Pull off the defective propeller with the fingers and en
-
sure that the motor shaft is not bent when pulling it off.
The new propeller is pushed not the motor shaft straight
from above and gently pushed on to the stop.
Important!
Do not apply any unnecessary force or unsuit-
able tools and observe the rotating direction
of the motors at all times when replacing the
propellers (see bottom figure in figure 16)!
When replacing mechanical parts use only original
spares available from the manufacturer.
The spare parts list is located on our website www.
conrad.com in the download section for the respective
product.
You can also order the replacement parts list by phone.
For the contact data, please refer to the top of these
instructions in the chapter "Introduction".
The arrow pointing up between the two blue propellers in figure 16 indicates the forward flight direction of
the quadrocopter.
The opening into which the flight battery is inserted (see figure 16, item 3) is on the opposite side with the
orange propellers.
Figure 16
