Safe-T-Reel Welding Hose Reels
Page 2
www.reelcraft.com
INSTALLATION INSTRUCTIONS
Inspection
Unpack and inspect reel for damage. Turn the reel by hand to check for smooth operation. Check for completeness.
Figure 1
Figure 2
Figure 3
Mounting of the hose reel
1. Four 1/2” diameter mounting holes are located at the base of the reel. Mount reel using four (customer supplied) bolts;
tightening them securely to ensure a solid, rigid attachment. (Figure 1)
Connecting the inlet hose
1. Apply thread compound to all threads.
2. Thread male connector of supply line into 90° elbow located at the back of the reel. Tighten securely. (Figure 2)
Connecting the outlet hose
1. Apply thread compound to all threads.
2. Thread male connector of hose into 90° elbow located within the spool. Tighten securely. (Figure 3)
CAUTION:
Fully extend and charge hose before winding onto reel. Momentarily open control valve, when initially charging to purge hose of
gases. When fluid appears at control valve, close valve. This prevents flattening of the hose and excessive pressure on the drum
when fluid supply is reinitialized at a later time.
