2.
COMPONENTS
1) Solar panel and ground spike 2) Pump 3) “Y” connector 4) Panel to battery cable 5) Battery station
6) Hose connection 7) Gland nut (M56 x 2.0mm) 8) Spare Impeller (not pictured)
3.
ASSEMBLING
1)
Unpack all components carefully
2)
Connect the INPUT cable of the battery back-up to the solar module or a
DC power supply, and tighten the protection screw.
The connectors are
protected against reverse polarity as shown in the right figure. Don’t
insert the plug with reverse polarity by using unnecessary force
.
3)
The CHARGE yellow LED indicator lightens when the battery is being
charged
no matter whether the system switch is ON or OFF;
otherwise the LED shuts off.
4)
Electrically connect pumps and any other applicable DC equipment to the appropriate output ports of the
battery station. The rubber covers for output 1 and output 2 are used to protect the ports when they are not in
use. Remove the cover of the output and Keep it appropriately for possible needs in the future. The rubber
cover for output 4 is used to protect the ports either in use or not in use. Please remove the cover and fit it
back after output 4 is connected following below steps.
Figure 2
FOUNTAIN FUNCTION
If you wish to use a fountain
nozzle (not supplied) you will
need to connect it using hose
from the hose connection (part
6 in Figure 2) as the thread
outlet on the pump is a
non-standard thread (M56 x
2.0mm)
FRONT
BACK