5
INSTALLATION INSTRUCTIONS
Important Note
The Wolfen shower seat should be properly assembled, installed and cared for. Failure to follow the
below instructions may result in serious injury.
The 960mm shower seat meets AS 1428.1-2009 and both seats are manufactured from high quality
stainless steel with a HDPE seat. It has been tested to a loading of 1100N. Proper care must be taken
to install the grab bar to an appropriate load bearing base, using appropriate fixing bolts.
Installation Instructions:
Shower seats are specifi cally designed for comfort
and stability while showering and drying off. They
can be mounted anywhere within the bathroom
provided the location has been planned with a
supporting in-wall mounting structure. The seats
are designed for the user to bathe safely.
1. Confi rm the contents of the box. The box
should contain 1 shower seat frame and
4 screws.
2. Test the up and down movement of the
seat, then set it down and consider the
following installations:
• When selecting the mounting location, install
only where there is proper structure support
within the wall. Measure the area of the seat
on the wall to avoid penetrating objects
behind the wall.
• The seat must be fl at (and not angled to one
side) when installed. Use a levelling tool
when adjusting the height of each leg.
3. After completing fi nal adjustments, position
the mounting legs close to the shower wall
and mark each hole location for drilling.
4. Drill the pilot holes.
5. Install the shower seat with the screws
provided. Inspect each screw to ensure
it is tight.
6. Test the seat by applying gradual pressure.
Maintenance
Clean product with mild soap and water.
Summary of Contents for Wolfen 9505996
Page 8: ...reece com au wolfen...
