![Reece Milli EXO WALL SINK SET Quick Start Manual Download Page 2](http://html1.mh-extra.com/html/reece/milli-exo-wall-sink-set/milli-exo-wall-sink-set_quick-start-manual_1430878002.webp)
SPOUT FITTING
Remove the set screw from the rear of spout
assembly and place somewhere safe. Carefully
place the push on wall plate onto the assembly
if not already done so.
Friction Bearing
Spout Base
Remove the friction bearing to avoid any risk of
loss or damage while fixing and tightening the
spout base.
page
2
of 4
O-rings
Remove the spout being careful not to damage
it or the a-rings.
Apply a sufficient amount of a good quality
thread sealant and in a clockwise direction
screw the spout base onto the outlet until
base is flush with the wall and the spout
nipple in a verticle position. Ensure seal
is achieved then push the push on wall
plate gently against the finished wall.
Re-assemble the spout assembly to
complete the installation.
EXO WALL SINK SET