page2 of3
MILLI
EXO TOILET ROLL HOLDER
Important Note
Tap must be installed to the requirements of AS/NZS 3500 by a qualified plumber. The tap seat should have a uniform
surface to allow a positve seal between the cartridge and the seat. Tap seats in poor condition must be re-seated.
INSTALLATION INSTRUCTIONS
In the desired location for the toilet roll holder, mark the three drill hole positions as shown in the
illustration below, ensuring the flat section of the wall bracket is horizontal and the three mounting holes
are in the orientation displayed.
WALL BRACKET
HOLE POSITIONS
I SPIRIT LEVEL
'<.5'
@1
Carefully drill ?mm holes in the previously marked positions and insert the wall plugs until flush with the wall.
(To ensure accuracy, we reccomend to use the wall bracket as a guide and drill pilot holes using a 4mm drill
bit prior to drilling the ?mm finished hole size required.)
NOTE : Always be aware of inwall plumbing and
electrical cables when drilling into wall cavities .
Fix the mounting bracket firmly in place using the screws supplied ensuring it is flush and firmly against the wall.
reece
