Lancaster 800 Double Bowl Butler Sink
Page 01
Due to the firing process at the Shaws factory, all Shaws handmade sinks have a +/- 2% tolerance in size, or up to a
maximum of 6mm variance in length or width.
It is therefore advisable to NOT cut or drill worktops or units until you have checked your individual sink size.
Please inspect your sink on delivery. The top and sides of your sink should be //- 2% tolerance.
Ÿ
It is recommended that two people are used to lift the sink into place.
Ÿ
No two sinks are alike, so installation templates are available. You will require the product to trace the template for
worktops and cover panels or surrounds.
Ÿ
Do not adhere the sink to the substrate board. If any warranty issues arise, this prevents easy removal and may result
in a fee to the customer.
Ÿ
Due to the weight of a Shaws sink, it is important that the cabinetry being used is of a suitable strength and sound
construction. A typical installation includes a timber support frame and a quality moisture resistant base board.
Ÿ
The wooden frame must be fixed to the cabinetry using appropriate screws or bolts.
Ÿ
Holes should be cut into the base board to allow the fitting of the waste to the sink. Additional smaller holes may be
required if you are fitting an overflow kit.
Ÿ
When fitting your benchtop in an undermount installation, you have the choice of a half reveal or no reveal (Refer to
diagrams below). In both methods, it is of the utmost importance to silicone between the sink and worktop.
Double Bowl Butler
Sink x1
Tools Required
Silocone
Level
Marker
Tape Mesure
Plumbing connections must be installed to the requirements of AS/NZS 3500 by a qualified plumber.
Modifying the product outside of the information in the installation is not recommended and will not
be covered under warranty.
of 09
