Page 2 of 3
Installation Instructions (continued)
Kado Lussi Heated Towel Rail Hardwired Wall Mount
1030 x 500mm Chrome
HYDROTHERM
MILAN HEATED WALL MOUNT TOWEL RAILS
HARD WIRING
It is
recommend
ed
that all hard-wired heated towel rails
be connected to a light switch or digital timer. Connecting hard-wired
heated towel rails to a light switch or a timer will prolong the life
of the electric element and reduce energy consumption.
CHANGING ELEMENTS
To change an element from one side to the other, or to replace
an old element is a very simple process.
There are Four Basic Steps:
1. Remove towel rail from brackets (if already installed),
and slip off Hard Wire Attachments
2. Turn the towel rail upside down and with a spanner loosen
the hex nut of the electric element. When the element is
loose, unscrew it by hand. If you are changing the element
from left to right (or vice versa) the internal plug on the
opposite side must also be removed and swapped over with
the element.
3. Swap the element and screw in place.
4. Turn the towel rail the right way up and position back into
brackets and refit grub screws to secure
Please note:
It is
advise
d
that the unit be removed from the wall and
turned upside down to ensure that water does not spill.
Ensure element always remains at bottom of towel rail.
page 4 of 5
Element
on left side
Turn rail
upside down
Swap
element over
Element
on right side
tu
ow
erc
sn
u
ni
we
rcs
we
rcs
nu
ni
we
rcs
1.
2.
3.
4.
