5. Select a display mode and monitor your
progress with the display.
As you walk or run on the treadmill, the display can
show the following workout information:
• A 1/4-mile (400 meter) track.
• The approximate number of calories you have
burned.
• The elapsed time.
• The distance that you have walked or run.
• The incline level of the treadmill.
• The speed of the walking belt.
When the manual mode is selected, the console of-
fers two display modes. Press the Display button
repeatedly to select the desired display mode.
Regardless of which display mode you select, the
speed or incline setting will appear in the display for
a few seconds each time you change the setting. In
addition, your heart rate will appear in the display
each time you use the handgrip pulse sensor or the
optional chest pulse sensor.
To reset the console, press the Stop button, re-
move the key, and then reinsert the key.
6. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
the optional chest pulse sensor at the same
time, the display will not show your heart rate
accurately.
Before using the
handgrip pulse
sensor, remove
the sheets of
clear plastic from
the metal con-
tacts on the pulse
bar. In addition,
make sure that
your hands are
clean.
To measure your heart rate,
stand on the foot
rails
and hold the pulse bar with your palms on the
metal contacts.
Avoid moving your hands
. When
your pulse is detected, a heart symbol will flash in
the display each time your heart beats, one or two
dashes will appear, and then your heart rate will be
shown.
For the most accurate heart rate reading,
continue to hold the contacts for about 15 sec-
onds.
7. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
or you may damage the treadmill when you fold
it to the storage position.
Next, remove the key
from the console and put it in a secure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord.
IMPORTANT: If you do
not do this, the treadmillʼs electrical compo-
nents may wear prematurely.
Contacts
15
