RedPlate PBBB Operations Guide
3
DUAL BOOST OPERATION
If nothing is plugged into the Return Jack, the signal will pass through the Send and Return and
feed the Output Buffer (Boost2). Each one of the footswitches will turn on their respective Boost
and you will notice each Boost is voiced differently. Boost 1 is warmer and can add some character
to your clean tone. Boost2 (Output Buffer) is clean and adds a hint of brightness. You can use
Boost1 set to a high level and Boost 2 set low to get a rudimentary overdrive effect. The Bypass
footswitch will cause the signal to skip Boost2.
POWER OPTIONS
1.
The PBBB operates at 9 volts DC. Almost any pedal power supply will connect to the
PBBB’s DC input jack (negative center). The unit will also run on a 9 volt battery. The
battery is located under the bottom plate. Remove the 4 screws to gain access. The battery
is not active when the DC jack is in use and also not active until something is plugged into
the input jack.
MAINTENANCE SECTION
Your PBBB amp has been designed for years of trouble free operation. The top of the PBBB
has a protective finish that can be easily scratched with abrasives so always use a damp soft cloth
to clean it
RedPlateAmps
1812 W Cinnabar AVE
Phoenix AZ 85021
Thanks again for joining the RedPlate Family
– Henry