you will hear a beep sound,the current temperature
is flashing.It’s in standby mode.Press the “ ” to start the appliance.
3.When appliance is in standby mode,press the set button for one
time to set temperature, when in this mode,the temperature is
blinking.Press the” + “or “– “adjust button to set the temperatu-
reup(from 00
℃
to 90
℃
) and down(from 90
℃
to 00
℃
).
4.When appliance is in standby mode,press the set button for two
times to set the hour, when in this mode,the hour is blinking.-
Press the” + “or “– “adjust button to set the hour up(from 00 to
99 hours) and down(from 99hours to 00).
5.When appliance is in standby mode,press the set button for
three times to set the minute. when in this mode,the minute is
blinking.Press the” + “or “– “adjust button to set the minute
up(from 00 to 59 mins) and down(from 59 mins to 00).
Step3. Fill the container or port with water.The water level
should be within the MAX and MIN marks. The water level will
rise up when immerse the food into the container or pot.So do
please not to fill it up too high. But near the Max is the most
suitable level to work
Note:
As the water temperature increases,the water will begin to
evaporate.
The circulator is equipped with an alarm which indicates
low water level. If the water level goes below the min
mark,the circulator will stop operating.
1. Plug it into the outlet. You will hear a beep for one second,The
“ ” button and working lamp will be on for one second then
power off.( working lamp are all blue)
2. Press and hold the “ ” button for 3 seconds,the screen is
unclocked and
