9. Maintenance
In case irregular wear is observed on a recoil boss
or reel bore, exchange for new components.
5. Remove the rope from the reel.
6. Make a knot in end of new rope and lead it
through a reel hole from outside. Pull the rope
hard to engage the knot into a reel pit and put
end of the knot into a reel notch. (MA19)
(1) Notch
In case the rope knot is too large or the rope end is
protruded from the reel, the rope retraction may
become difficult.
7. After leading the rope through a guide of recoil
case, align a notch in the back of reel with end
of the coil spring. Assemble a spacer and the
reel to the recoil boss. By turning the reel left
and right, engage the reel notch with the spring
end.
8. Put a washer on the recoil boss and fix the
screw as original.
9. Lead the rope through a guide hole on the
starter case, starter knob and a washer and
make a knot (double overhand knot). (MA20)
10.Pull out the rope from a notch in the reel rim
and turn the reel 4~5 turns clockwise. (MA21)
(1) Notch
11.Holding the reel with left hand, pull out the rope
with right hand. Ease the left hand and let the
IMPORTANT
NOTE
29
MA19
MA20
MA21
