RedMax 967684801, Workshop Manual, Page: 11 / 81

1. Put the start inhibitor (E), plastic clips (F) and
springs (G and H) in the handle.
F
F
F
G
G
H
E
G
2. Put the relay with cables (D) and the loop (C) in the
handle.
C
D
3. Attach the handle halves with the 10 screws.
4. Make sure the safety catch moves to the rear in all
directions.
5. Put the cables through the hole (B) in the chassis
and connect the plugs (A) to the control unit.
A
B
CAUTION: Make sure that the safety catch
operates correctly when the plugs (A) are
connected.
6. Assemble the gear housing and motor in the
chassis. See
To assemble the gear housing and
motor in the chassis on page 12.
7. Assemble the right half of the chassis. See
To
remove the front handle on page 9.
8. Attach the front handle in opposite sequence of
To
disassemble the front handle and start inhibitor on
page 10.
5.5 Power trigger
5.5.1 To disassemble the power trigger and handle
stop
1. Disassemble the front handle and the right chassis
half. See
To remove the front handle on page 9 and
To disassemble the chassis on page 8.
2. Disassemble the rear handle. See
To disassemble
the rear handle on page 17.
3. Remove the handle stop (A) and the spring (B).
Remove the power trigger (C).
C
B
A
580 - 001 - 27.03.2018 Repair instructions - 11