English – 21
Electrical system
9 Electrical system
9.1 Ignition system
9.1.1 Dismantling
1. Remove the cylinder cover and starter unit. See
page 16.
2. Release the blue lead (A) (which connects to
the stop button) from the ignition module (B).
See fig. 1.
3. Remove the ignition cable (C) from the spark
plug and release both cables from the cable
guide (D), and lift off the cable guide. See fig. 1.
4. Remove the two M5 bolts and lift off the ignition
module (B). See fig. 1.
5. Remove the two pawls (E) for the starter. See
fig. 1 and fig. 6.
6. Remove the spark plug and fit the piston stop in
spark plug hole. See fig. 2.
7. Release the flywheel nut. Unscrew the nut until
it comes level with the outer end of the shaft
thread See fig. 3.
8. Fit the flywheel puller. Tighten down the two
M5x25 bolts approx. 10 turns. Tighten the centre
bolt, while preventing rotation with the holding
tool until the flywheel releases. See fig. 4.
9. Remove the puller, nut, washer and flywheel.
9.1.2 Cleaning and inspection
Clean all parts, especially the tapers on the fly-
wheel and shaft.
Check the flywheel for cracks or any other signs of
damage.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
C
A
B
E
D
F
