OPERATION INSTRUCTIONS
Proper Operation of the Log Splitter
Always follow Operational warnings & check-list before operating!
1.) Carefully place a log on the Splitting Table
(10)
. Maximum length of the log
suitable for the logsplitter is 60cm.
2
.) Start Engine by using the following instructions:
a.) Turn the engine switch to 'ON' position.
b.) Slide the choke lever away from the fuel tank to activate the choke.
c.) Turn the fuel tap on.
d.) Raise the engine revs by sliding the throttle lever away from the fuel tank.
Always use full throttle when using the machine.
e.) Pull the starter cord handle lightly until resistance is felt, then pull briskly.
f.) When the engine starts to run, deactivate the choke by sliding the lever
towards the fuel tank.
4.) Start the splitting procedure by pushing and holding the Control Valve Lever
(7)
forward. Please note the Splitter Wedge
(8)
only moves downward when you
are holding the lever forward. When you let go of the Control Valve Lever
(7)
the
Splitting Wedge
(8)
stops immediately for safety reasons.
5.) To return the Splitting Wedge
(8)
to its starting position, simply pull the Control
Valve Lever
(7)
backwards. Please note the Splitting Wedge
(8)
returns back to
the original starting position automatically after the Control Valve Lever
(7)
is
returned to its neutral position. Also, please note that for safety reasons, the
Splitting Wedge
(8)
stops approx. 3-4cm from the Splitting Plate.
6.) Always make sure that the operator zone is clean and free from split wood
and debris.
7.) Repeat the above steps as required.
PREPARING THE LOGSPLITTER FOR USE
Before operating the logsplitter, make sure that both the supports legs are firmly set on
the ground and that both the tired have been blocked.
This is necessary to prevent unnecessary movement of the log on the Logsplitter
Splitting Table
(10)
.
8