13
10.0
START/STOP PROCEDURE
The start procedure is
VERY
important. If this procedure is not executed as described below, serious
damage to the machine / subsoil could be the result.
The start procedure is as follows:
1.
Check the Verti-Top Pulled for loose components and look whether all components function
properly.
If loose components are observed or components do not function properly, the
problems must be solved
before
using the Verti-Top Pulled!
2.
Drive to the spot where the processing should take place.
3.
Set the working depth of the machine statically as described in Chapter 5.0.
Make sure that the towing vehicle is blocked well and cannot move on its own
accord!
Switch off the vehicle before descending!
Make sure that the ON/OFF switch for operating the electrical coupling is OFF!
Figure 10
Figure 11
Figure 12
4.
Start the motor of the Verti-Top Pulled
(Figure 10)
.
5.
Set the slide switch of the motor
(Figure 11)
in the highest position.
6.
Ascend the vehicle, start moving it forward and switch the electrical coupling ON by means of
the switch
(Figure 12)
.
7.
Increase the driving speed to maximum 12 km/h (7.5 mph).
Stopping occurs as follows:
1.
While driving, switch OFF the
electrical coupling
(Figure 12)
.
2.
Stop the vehicle.
Make sure that the towing vehicle is blocked well and cannot move on its own accord!
Switch off the vehicle before descending!
3.
Set the slide switch of the motor
(Figure 11)
in the lowest position.
4.
Switch OFF the motor.
5.
Lift the machine, drive to the next location and start the operation as described above.
