12
9.0 STARTING/STOPPING PROCEDURE
The starting procedure is VERY important. If this procedure is not followed exactly as described
below, serious damage may occur to the ground underneath the machine.
The starting procedure is as follows:
1. Check the Verti-Groom thoroughly for loose parts and make sure all parts function properly.
!! If parts are found that are loose or do not function properly, correct the situation
before using the Verti-Groom!!
2. Drive to the place where the soil is to be treated.
3. Turn the top rod 3 in so that the machine is at right angles to the ground.
(see fig. 8)
4. Adjust the working depth while the machine is stationary as described in chapter 6.0.
!! Ensure that the tractor is well blocked and cannot start moving by itself !!
!! Switch the tractor off before dismounting !!
5. Lower the machine until it hangs approximately 50 mm (2”) above the ground.
6. Put the tractor in the correct gear.
7. Drive the tractor forward and lower the Verti-Groom smoothly onto the pre-adjusted running
wheels.
8. Increase the driving speed to a maximum of 12 km/h (7.5 mph).
Stopping is done as follows:
1. While moving, raise the machine smoothly.
2. Drive to the following location and start again as described above.