12
5.2 USING THE PTO
The following items must be checked for correct use of the PTO:
1. While working the angle of the pivot pins may not exceed 30 degrees.
2. The pivot pins must always be aligned.
3. The overlap of the cylinders must always be minimum 150 mm.
4. Never use the machine if it has a damaged PTO protection cap.
5. For lubrication, please refer to Chapter 12.0 ‘Maintenance’.
Figure 9
6.0 ADJUSTING THE WORKING DEPTH
Adjusting the top rod (1) will set the working depth of the machine.
Turning the top rod in or out will adjust the working depth
(see Figure 9)
.
7.0 TRANSPORTING THE VERTI-CUT
The user is responsible for transporting the Verti-Cut in back of the tractor over public
roads. Verify the national legislation regarding the regulations. A maximum speed of 20
km/h (12.4 mph) – on condition that circumstances permit this – should be observed
when driving over fields with the machine in a lifted position. Higher speeds can
endanger the driver/public and may even damage the machine.
When the machine is raised off the ground, the front axle of the tractor has
to support minimum 20% of its weight.
8.0 THE WORKING SPEED
The working speed of the Verti-Cut is maximum 5 km/h (3.1 mph). However, in practice you
should adjust your speed to the soil that has to be treated
and
the required working depth.