11
17.
Safety decal 911.280.402:
Keep distance to the machine, switch off engine and
lock machine when maintaining or adjusting and be aware of moving parts.
18.
Lift cable.
19.
Shoe.
Should be close to the ground all the time. So adjust them when height is
altered
.
20.
Nut holding the shoes.
21.
Main V-belt drive cover.
22.
Rear roller for anti scalping. Should be approximately 10 mm (3/8”) above the
ground
23.
Manual box with operating manual and decal RA:
Read manual first.
24.
Top guide rod head. Is adjustable. See manual for further instructions, when
necessary.
25.
Access door head.
SHOULD ALWAYS BE ON AND SECURED
.
26.
Bottom guide rod head. Is adjustable. See manual for further instruction.
27.
Rear wheel.
28.
Safety decal: Keep fingers away.
•
All safety decals and protection covers should be on the machines all time. If
damaged or lost, replace them immediately.
•
Never creep under the tipped hopper.
•
When tipping or dropping the hopper, everyone should stand clear 4 mtr (16’) from
the machine.
•
Do not stand between the tractor and the machine
•
When adjustments are needed, switch the engine off.
5.0 PTO.
The PTO is a very important item. It drives the machine from the tractor and ensures the safe
operation when correctly maintained and installed. The PTO shaft has its own CE
certification. Read the PTO shaft manual, which is connected to the shaft itself.
Some important notes on the PTO drive, see Fig.2,3,4.:
1.
It is very important that the joint angles 21 and 22 are the same. If the difference is more
than 10 degrees, the rotational speed to the gearbox 23 starts to be irregular. This will
create vibrations in the drive line towards the rotors and will cause damages to the
machine.
2.
The difference under 1 arises e.g. when we make (tight) turns with the machine when
used as a sweeper. That will create damages to the machine in the end. If people want to
make (tight) turns during work a wide angle PTO is necessary.
3.
Under normal conditions ( making straight passes) we will not create vibrations on the
drive line if the machine is well set, see chapter 3.
•
The unit may not be used when the PTO cover is damaged. Replace immediately.
•
Be sure the PTO protection cover is assembled and undamaged too
•
For maintenance, see the instructions on the PTO shaft.
•
The maximum speed of the PTO is 540 rpm’s
