Receiver LED quick flash then green LED keep light it means bind is accomplished.
II. Please make sure the transmitter in binding process.
III. To set fail-safe throttle and control surface positions, (minimum throttle and all
control surfaces set to neutral is suggested). Press and hold the bind button of transmitter
(LED will illuminate), Turn on the transmitter.
III. Receiver LED will change from rapid flashing to slow flashing and a few seconds
later when bind is accomplished the LED of receiver will illuminate solid. Failsafe should
be programmed correctly .
IV. Remove binding harness from the BIND channel. Restart the receiver by cycling it
power off and turn on and connect battery into BIND channel is recommended. All
channels should function properly now. You may test fail-safe by holding sticks in
corner, cycle transmitter on and off. Surfaces and throttle should return to your preset
fail-safe positions.
Notes:
Only one time bind procedure is required on a new receiver. Repetitive binding
provides no extra security. Always remember to remove the binding harness after
successful bind is completed.
Package including: CM410X Receiver *1 pc
Summary of Contents for CM410X
Page 3: ......
