1
Scissors
Wire Cutter
Needle Nose Cutter
4-way Wrench(small)
4-way Wrench(large)
Hobby Knife
Sleeve(16mm)
Sleeve(23mm)
Hex Wrench
(1.5/2.0/2.5/3.0/4.0/5.0mm)
Engine View
Note:The engine is sticked with warning labels,
please pay special attention on it . The image is
presented for your reference only.
Throttle Lever
to control the fuel
inflowing
Recoil Starter
Off Switch
Clutch Bell
Glow Plug
Air Back Needle Valve
Fuel Inflow Mouth
Air inflow switch
Fuel Composition:
Unleaded GStroke Oil(Gasoline about 75%
+Stroke Oil about 25%),Please mix the two different
fuel to start your engine.
2
Tools For Assembling Your Model
Specifications:(Buggy)
1.Engine:26/30CC
2.Steering Servo:20KG-cm Throttle Servo:9KG-cm
3.Length:760mm
4.Width:460mm
5.Height:280mm
6.Weight:9KG
7.Wheelbase:500mm
8.Drive way:Shaft drive
9.Ground Clearance:40mm
10.Wheels(Diameter /Width):150mm &60mm
11.Fuel Tank Capacity:500CC
12.Drive System:AWD
13.Diffirential System:CNC process metal gear
14.Brake Syetem:double brake disc turn round sytem
15.Gear Ratio:1:8.9
16.Receiver battery/charger:2000/2500mAh,Ni-MH battery
17.Body:anti-explode,high resistance
18.Camber Angel:0-35
19.R/C Control System:2.4GHz RADIO SYSTEM
20.out of Control protection:standard protection equip
Important Safety Precautions
Replace the shield body after adjustment and before driving.
Do not abruptly alter the speed during running.
Carefully check whether all screws or nuts are loose or not after running.
Never measure the fuel close to open fire or any source of heat.
Never run the vehicle without a clean air filter installed.
Do not run the model lean and do not allow the engine to overheat.
Use the special fuel for models.
Store fuel in cool,dry and dark places away from Children's reach!
Tighten the cap of the fuel bottle when not used..
Do not put your finger or any object into the rotating or moving parts.
To avoid the danger of burns, do not touch the engine and muffler immediately after
they have stopped running.
Before Starting Your Vehicle
Verify that all retainers are well fastened (screws, nuts, bolts and clips)
Verify proper function of steering, drive-line and engine/braking control.
Lubricate appropriately all bearings, bushings and maintain proper shock performance.
Always run engine with a clean oiled air filter.
Inspect fuel tank for cracks and/or kinks in silicone tubing. Correct problem if required.
Inspect tune-pipe for damage; make sure it is well fastened to engine/chassis.
Operate radio system with fully charged batteries; perform radio frequency/range check.
Inspect terrain for hard/non-movable objects that may become a hazard for your vehicle.
Provide adequate clearance between your vehicle and your observers.
Do not operate vehicle on public roads, or obtain adequate authorisation to permit usage.
Specifications:(short course)
1.Engine:26/30CC
2.Steering Servo:20KG-cm Throttle Servo:9KG-cm
3.Length:900mm
4.Width:460mm
5.Height:300mm
6.Weight:10KG
7.Wheelbase:500mm
8.Drive way:Shaft drive
9.Ground Clearance:40mm
10.Wheels(Diameter /Width):155mm &72mm
11.Fuel Tank Capacity:500CC
12.Drive System:AWD
13.Diffirential System:CNC process metal gear
14.Brake Syetem:double brake disc turn round sytem
15.Gear Ratio:1:8.9
16.Receiver battery/charger:2000/2500mAh,Ni-MH battery
17.Body:anti-explode,high resistance
18.Camber Angel:0-35
19.R/C Control System:2.4GHz RADIO SYSTEM
20.out of Control protection:standard protection equip
Specifications:(Truck)
1.Engine:26/30CC
2.Steering Servo:20KG-cm Throttle Servo:9KG-cm
3.Length:750mm
4.Width:540mm
5.Height:320mm
6.Weight:10.5KG
7.Wheelbase:500mm
8.Drive way:Shaft drive
9.Ground Clearance:40mm
10.Wheels(Diameter /Width):180mm &110mm
11.Fuel Tank Capacity:500CC
12.Drive System:AWD
13.Diffirential System:CNC process metal gear
14.Brake Syetem:double brake disc turn round sytem
15.Gear Ratio:1:9.6
16.Receiver battery/charger:2000/2500mAh,Ni-MH battery
17.Body:anti-explode,high resistance
18.Camber Angel:0-35
19.R/C Control System:2.4GHz RADIO SYSTEM
20.out of Control protection:standard protection equip
Features:
1.High quality main/diff.gears.
2.Four wheel centre drive system,solid universal joint cups,high performance Full ball bearing
3.Fiberglass brake disc provides quick brake response under high temperature.
4.Fold stylish and solid full anodized aluminum 6061chassis.
5.New design solid roll cage protects the inner instruction perfectly.
6.Enhanced suspension arm system,solid front/rear shock tower.
7.Powerful engine system with air filter.full aluminum polished exhaust pipe.
