Redcat Racing EARTHQUAKE 8E, Instruction Manual

Page: 5 / 16

2
.
4G Operation notes
Bind cable
Figure 1
Matching (code
)
A
.
Install the battery to 2.4G transmitter and shut it down.
B
. (
Insert the bind cable to the channel BIND/CH3 port of the receiver. Figure.
C
.
Connect the receiver battery to VCC port of the receiver, at the same time the two LEDs are flashing,
D
.
Press and hold the button on the transmitter, and then switch on the power supply.
F
.
Release the match button on the transmitter, take out the bind cable.
E
.
Observe the LED on the receiver, if the LED does not flash anymore, that means the successful. matching is
G
.
Install the server and then test.
H
.
If the test fails, please repeat the actions above.
I
.
If the test succeeds, then insert the power supply port into VCC, match complete.
well matched in the factory, you do not need to match them. But if you The transmitter and the receiver are
are going to match the receiver with another transmitter, or
if
you need to change a new receiver
or transmitter
,
please follow these steps:
this means the receiver is going to the matching status.
(This takes about 5s)
LED
Battery
Receiver
4
Note
:
Don
'
t put it close to the metal thing for assuring its sensitivity
.(
See 1
)
Figure
Place the antenna of the receiver vertically with the truck
!
Receiver
ANT
Figure 1
Bind key