Please note: If you are using a Dimmable driver, but are not deploying the Dimming feature, to guarantee full
power is being delivered by the driver, the DIM + [yellow] lead should be connected to the Vcc Aux power
[blue] lead. The White DIM - lead should be terminated using electrical tape or a wire nut.
4.
Strip approx. 3/8“ – 7/16” off the end of the RED and BLACK leads on the driver’s low
voltage DC Output side, and connect to the WAGO-style connector at either end of the first
Stripit Kit LED strip; POLARITY MUST BE OBSERVED IN THIS STEP. Make sure to connect
the RED wire to the + push-in terminal and the BLACK wire to the – push-in terminal To
make sure the wires have been completely engaged in the push-in terminals, gently pull on
the wires to ensure they can’t be pulled out.
5.
Using the supplied TEK screws, mount the first Strip in the fixture (connect the lead wire
before mounting the LED strip in the fixture], via the mounting screw holes at each end of the
Strips
Connecting Additional Strips
6.
Measure distance between strips and cut a suitable section of the 18 gauge wire to length.
