Redback 106065, Operation Manual, Page: 8 / 16

8
Line Trimmer Assembly
Set the shaft length
Adjust the trimmer length to the height of the user (see Figure
7). Loosen the threaded sleeve on the shaft coupling
1
. Extend
the lower shaft until the ideal handle length is reached
2
.
Tighten the threaded sleeve
3
.
Set the handlebar
Adjust the handlebar to the height of the user (see Figure
8). Loosen the locking lever on the handlebar
1
. Set the
handlebar to the required position
2
. Secure the handlebar by
folding down the locking lever.
Set the operating angle
Five operating angles can be adjusted on the lawn trimmer (See
Figure 9). This allows you to easily reach places in the garden
which are problematic and difficult to access. The cutting head
should always be parallel to the ground. Press the locking
button
1
. Set the required operating angle
2
. Release the
locking button.
Inserting/Replacing the Battery
Charge the battery as described in the charger operation
manual. Attach the charged battery into the power tool by
positioning, aligning and then sliding the battery into the power
receptacle on the line trimmer until it clicks into place (see
Figure 10). To remove, press the release button and pull out the
battery.
Protect the battery contacts when the battery is not being
used. Metal objects may short-circuit the contacts and pose
both an explosion and fire hazard!
!
CAUTION
BATTERY
RELEASE
Figure 10
Figure 7
1
2
3
Figure 8
1
2
1
2
Figure 9