11
www.redbacklasers.com.au
Vertical Rotation Operation
(refer to diagram page 4)
The EGL624G can be used on its side for vertical alignment or together with
the dot laser out of the front to produce a 90 degree square for site layout.
The EGL624G can be placed on its side with the datum marker open or
closed and roughly levelled using the adjustment feet and bubble vial in the
handle, this brings the laser into self levelling range where the electronics
take over.
Note in vertical rotation mode features such as “TILT”, “V-W-S” and “Scan”
can still be used the same as when in normal horizontal rotation mode.
When on its side press Slope button the “X” LED will light and the Slope/
Manual direction buttons on remote can be used to shift the dot/
rotating line to the left or right. This is ideal for site layout squaring;
•
Place datum marker over the datum point marking the conjunction of
the 90 degree lines.
•
Roughly align laser housing so dot is striking target point along the one
line of the 90 degrees, then use the direction buttons to electronically
fine tune this alignment.
•
Once the dot is on the target use the receiver to pick up the rotating line
on the second line of the 90 degree. Your square is now set.
Rotation Scan Modes - For Indoor Visibility
The Scan Mode stops the laser from rotating and toggles the beam left to
right, intensifying the beam making the laser more usable indoors as a visible
laser. You can set the scan angle to 180
o
, 90
o
, 45
o
and 10
o
and shift the beam
both left and right. The Scan Mode can be operated by both the Control key
pad on the laser and also the Remote Control.
•
Press the Scan button to enter scan mode.
•
The first press, area scan 180 °, second press 90°, third press 45°,
fourth press 10°, fifth press 180° etc….
•
Rotate the scan line left or right by pressing Scan Shift buttons
as indicated by direction arrow on button.
•
Press and hold Scan Shift button to rotate the scan line quickly.
•
To return to rotation mode press the Rotate button .
Summary of Contents for EGL624G
Page 1: ......
