CONFIGURE START/STOP, GENLOCK, TIMECODE,
TALLY
This section explains how to set up start/stop, genlock, and timecode with the W.M.D. and a camera.
For more information about cables and configurations, go to
"3-Axis System Cables" on page 75
.
1. Configure Start/Stop in the camera menu.
A. Go to
Menu
>
Settings
>
Setup
>
GPIO/Sync
>
Brain GPIO
.
B. Select
General Purpose In
from the
Camera In
drop-down menu.
2. Connect a RED Start/Stop Cable(s) for the configuration that you want.
FUNCTIONS
CABLE
PART NUMBERS
HOW TO CONNECT
R.C.P., Start/Stop with
Tally, allows Genlock and
Timecode to be
connected to the camera
RED Start/Stop
Cable (1B to
Sync, Ctrl, BNC)
790-0415
1. Connect the 14-pin 1B LEMO to the
EXP
port on the W.M.D.
2. Connect the 4-pin LEMO start/stop
connector to the
CTRL
port on the
camera.
3. Connect the BNC connector to the
White BNC connector of the 3BNC-to-
00 LEMO Sync Cable using a BNC-TO-
BNC Adaptor (included with the RED 3-
Axis Lens Control System).
3BNC-to-00
LEMO Sync
Cable
790-0154
1. Connect the 4-pin 00 LEMO connector
to the
SYNC
port on the camera.
Start/Stop, allows
Genlock and Timecode to
be connected to the
camera
RED Start/Stop
Cable (1B to
BNC)
790-0416
1. Connect the 14-pin 1B LEMO to the
EXP
port on the W.M.D.
2. Connect the BNC connector to the
White BNC connector of the 3BNC-to-
00 LEMO Sync Cable using a BNC-TO-
BNC Adaptor (included with the RED 3-
Axis Lens Control System).
3BNC-to-00
LEMO Sync
Cable
790-0154
1. Connect the 4-pin 00 LEMO connector
to the
SYNC
port on the camera.
Start/Stop
RED Start/Stop
Cable (1B to 00B
Sync)
790-0428
1. Connect the 14-pin 1B LEMO to the
EXP
port on the W.M.D.
2. Connect the 4-pin 00 LEMO connector
to the
SYNC
port on the camera.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
3 0
RED 3-AXIS SYSTEM OPERATION GUIDE
