3.2. Installing the Door/Window Sensor
• Mount the transmitter on a fixed surface such as a door or a window frame.
• Mount the magnet on a movable surface such as a door or a window.
• Ensure the >/< marks on the sides of the transmitter and magnet match up as shown in Fig.2.
• The transmitter and the magnet must be no more than 5mm apart
3.3. Mounting with the double-sided adhesive pad
• Ensure the mounting surface is clean.
• Peel back one layer of the protective film and attach it to the transmitter.
• Peel back the remaining layer of protective film and press the transmitter firmly in place against the
mounting surface until firmly attached.
• Repeat to attach the magnet.
4. House Security Code Settings
Unless the factory settings of the Wire-free Home Protection System Smart Panel have been altered, the
House Security Code will NOT need to be changed.
However, if the settings on the Smart Panel have been altered, or need to be altered to solve the problem of
the Smart Panel and sensors activating intermittently (or not working at all) or interference with other
systems, then the House Security Code on all system modules (sensors and sirens)will also need to be
changed.
House Security Code settings can be altered as follows:
• There are 4 jumpers or dip-switches on each device.
• Remove the [jumper compartment cover], then pull out or plug the jumper into the contacts to change the
House Security Code
• If a jumper is plugged it is ON if it is removed it is OFF. Default code is with all the jumpers plugged
• To ensure the system works correctly, make sure the jumpers on the Smart Panel and all other system
modules (sensors and sirens) match exactly.
Dip-Switches
for house
security code
- Key Fob Remote
Default house code: 1: ON, 2: ON,
3: ON, 4: ON
Jumpers for
house security
code
- Smart Panel
-Each sensor
Default house code:
1: ON, 2: ON, 3: ON, 4: ON
*Jumper: ON = Plugged, OFF = Pull Out
. 2 .
Fig. 2
