Collection Cup
An o-ring located on the Throat of the Reaction
Chamber holds the Collection Cup in position above
the Main Body. To remove / replace the Collection
Cup simply pull / push the Cup with small back and
forth rotations. The Collection Cup Cover is removed
by pulling it upwards and away from the Cup.
The Collection Cup has a drainage port for the constant
removal of waste. To connect a waste pipe remove the
Drain Plug from the port. When not using a waste pipe
make sure that the drainage port is plugged!
For Hang-on installations
a strainer is provided on
the aquarium side of the Inlet Pipe to prevent large
particulate matter or livestock from inadvertently being
sucked into the skimmer. Attach the Strainer to the Inlet
Pipe by aligning the pins on the inside of the Strainer with
the slots on the outside of the inlet Pipe. Push the Strainer
onto the Pipe and rotate to lock into position.
For Sump installations
an Extension Pipe is provided on
the aquarium side of the Inlet Pipe to allow for the lower
water levels typical of a sump. Attach the Extension to
the Inlet Pipe by aligning the pins on the inside of the
Extension with the slots on the outside of the Inlet Pipe.
Push the Extension onto the Pipe and rotate to lock into
position. The o-ring located on the Inlet Pipe seals the joint.
5. Prizm Pro Accessories
Surface Skimmer
– (included in Prizm Pro Deluxe)
The adjustable height Surface
Skimmer is an attachment to the Inlet Pipe
(instead of the Strainer) that directs the more
protein-loaded water from the water surface
of the aquarium into the skimmer.
To connect the Surface Skimmer to the Inlet
Pipe hold the Surface Skimmer below the
Inlet Pipe. Align the notched rail on the Inlet
Pipe with the Slot on the Surface Skimmer.
Press the Ratchet lever outwards, towards
the edge of the Surface Skimmer and slide it
up the Inlet Pipe. The correct position for the
Surface Skimmer should be set once the
Prizm Pro is installed on the aquarium.
6
In addition to being the water
inlet, the Inlet Pipe houses the
Air Inlet Tube and Flow Regulator.
To attach the Inlet Pipe to the
Pump:
Place the Inlet Pipe above
the Pump in Position 1 as shown
in the diagram below aligning the
arrows on the Inlet Pipe with
those on the Cover. With small
movements clockwise and anti-
clockwise of a few degrees, push
the Inlet Pipe downwards and
thereafter lock the Inlet Pipe in
position by rotating it clockwise
90 degrees to position 2.
To attach the Inlet Pipe & Pump Assembly to the Main Body
first remove
the Clamp from the Pump Support by pressing on the snap-lock release lever.
Lay the Main Body flat on a horizontal surface with the Air/Water inlet towards
you. Hold the Inlet Pipe & Pump Assembly in a vertical position. With small
movements clockwise and anti-clockwise of a few degrees, push the Pump
Outlet completely into the Air/Water inlet of the main body.
5
Postion
-2-
Postion
-1-
Slide the Clamp into the Pump support
and press firmly on the snap-lock until it
clicks into position.
Rotate the Inlet Pipe & Pump
Assembly anti-clockwise by 90
degrees until the Pump Cover
is seated in the Pump Support
of the Main Body.