red roo HT912, Operation, Safety & Maintenance Instructions, Page: 9 / 32

9
The clutch cable and lever must have some free play. The cable will stretch an
d
occasionally needs adjustment.
WHEEL DRIVE VALVE CABLE ADJUSTMENT
1.
2.
3.
Rotate the actuator arm clockwise, by hand, to take up any free play. Measure the distance from the pin
of the actuator arm to the end of the cable housing.
Pull the clutch level all the way up until it touches the handle bar grip. With the lever pulled up, again measure
the distance from the pin of the lever to the cable housing. Calculate the difference.
Adjust the cable for 7/16” to 1/2” movement of the actuator arm at the pin. Do not include any level free play
in the measurements.
The speed control cables may need to be adjusted after some use. If the machine creeps while the speed
control is in neutral, the speed cables will need adjustment. Adjust the cables to bring the pump cable arm
to the neutral position (vertical) when the speed control also is in neutral. Adjust the cables to eliminate
slack, but do not over tighten them so they are extremely tight against each other.
WHEEL DRIVE NEUTRAL ADJUSTMENT