Red Pitaya HAMlab 160-6 10W, User Manual

Page: 74 / 78

Red Pitaya HAMlab Documentation
The manual is made on the site https://trcvr.ru 74
6. Troubleshoot
6.1. Damaged or corrupted SD card
HAMlabs equivalent for getting your system back into factory settings is preparing new SD-card. This
should be done in case of SD-card failure. In that situation new HAMlab OS memory card will have to be
prepared. Please follow this steps to achieve this:
1. Power off HAMlab
2. Remove SD-card from HAMlab
3. Insert SD-cart into computer
4. Follow Prepare SD card guide to create new SD-card with HAMlab OS
In case that written SD-card does not behave as expected please use new SD-card, size should be at
least 4 Gb and it should be specified as class 10.
6.2. Power SDR cannot connect to HAMlab
After clicking Power button the Power SDR application should automatically connect to HAMlab and
receiving signal should appear in the panadapter. If the following msg. appears on screen after clicking
the Power button this means that:
1. HAMlab might not be connected to same network as computer that is running Power SDR
application
2. SDR transceiver application was not started or is not running on HAMlab
When trying to run PowerSDR please run SDR HPSDR web application before starting Power SDR.
6.3. Audio board not working
(This troubleshoot is only for HAMlab 80-10 10W model)
If audio there is no sound coming from your headphones or speaker connected to HAMlab while running
Power SDR application please make sure that: HAMlab is connected to PC that is running Power SDR
with USB cable
Check audio setings on your computer