Red Panda CONTEXT 2, Owner'S Manual

Page: 10 / 37

10
Controls
Each knob on the Context has a primary and secondary function.
Editing Alternate Controls [SHIFT]
Press and hold the
[SHIFT] button to adjust alternate parameters shown in light blue. Settings are
stored in presets and remembered when the pedal is turned off. Alternate functions are labeled [SHIFT]
in the following sections.
When shift mode is on, the right LED changes from blue to cyan and the left LED indicates whether the
input signal is above the dynamics threshold:
Off - signal is below -48 dBFS.
Green - signal level is below threshold
Yellow - signal level is at threshold
Red - signal level is above threshold
To edit [SHIFT] settings:
1. Hold the [SHIFT] button until the LED changes to cyan
2. While holding the [SHIFT] button, adjust the knobs and mode switch as desired
3. Release the [SHIFT] button to store the setting
Double click the [SHIFT] button to enable shift lock. The knobs now adjust alternate parameters until the
[SHIFT] button is pressed again:
1. Double click the
[SHIFT] button. The LED will change to cyan and blink blue to indicate that shift lock
mode is engaged.
2. Adjust the knobs and mode switch as desired
3. Press the
[SHIFT] button to store the setting and exit shift lock mode
BLEND / [BAL]
Adjusts the wet/dry mix, from 100% dry to 100% wet.
[SHIFT]-BAL sets the balance between reverb and delay. Note that if DELAY and FDBK are both set to 0,
the delay is off and
BAL will have no effect (100% reverb).
PRE / [DELAY]
Adjusts the predelay (0-150 ms).
[SHIFT]-DELAY adjusts the delay time (0-1200 ms). Setting both DELAY and FDBK to 0 will turn off the
delay.
DECAY / [FDBK]
Adjusts the reverb decay time.
[SHIFT]-FDBK adjusts the delay feedback. Setting both DELAY and FDBK to 0 will turn off the delay.