TOTALIZER AUTO RESET
22
This parameter automatically resets the Setpoint Assigned Totalizer (A or B)
each time the setpoint value is reached. The automatic reset can occur at output
start (
) or output end (
). The reset at output end selections will only
appear if the Totalizer Setpoint Action is Timed Out. This reset may be different
from the Totalizer Reset Action selected in Module 4.
SELECTION
ACTION
No Auto Reset
Reset to Zero at the Start of output activation.
Reset to Count Load Value at the Start of output activation
Reset to Zero at the End of output activation (timed out only)
Reset to Count Load at the End of output activation (timed out only)
SETPOINT RESET WHEN SPn+1 DEACTIVATES
SETPOINT RESET WHEN SPn+1 ACTIVATES
Select
, so the setpoint output will deactivate (reset) when SPn +1
activates. (Example: SP1 deactivates when SP2 activates and SP4 when SP1
activates.) The last setpoint will wrap around to the first.
Select
, so the setpoint output will deactivate (reset) when SPn +1
activates and then times out (deactivates). This function may only be used if the
SPn+1 is programmed for Setpoint Action of
. (Example SP1 deactivates
when SP2 is activated and then times out.) The last setpoint will wrap around
to the first.
SETPOINT RESET WITH DISPLAY RESET
Select
, so the setpoint output will deactivate (reset) when the Setpoint
Assignment (
) totalizer display resets. Note: The output will not reset if the
assigned totalizer is reset by a setpoint generated Totalizer Auto reset.
(For Reverse Action, The Alarm state is opposite.)
SETPOINT (ALARM) FIGURES FOR RATE
LOW ACTING WITH NO DELAY
LOW ACTING WITH DELAY
HIGH ACTING WITH TIMEOUT
LOW ACTING WITH TIMEOUT
HIGH ACTING WITH NO DELAY
HIGH ACTING WITH DELAY
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com
