N-Tron
®
Series NT24k
®
Compact Hardware Manual
2-76
Hardware Installation
Revised 2016-07-15
Unpacking
Drawing No. LP0987
Chapter 2
Hardware Installation
2.1 Unpacking
Remove all the equipment from the packaging and store the packaging in a safe place. File any damage claims
with the carrier.
Make certain the NT24k
®
Ethernet Switch package contains the following items:
1.
NT24k switch
2.
Product CD
2.2 Mounting the NT24k Unit
Red Lion offers its NT24k Panel Mount Assembly (P/N: NT24k-NM-PMK) which may be used to securely mount
the NT24k products to a panel or other flat surface.
A clearance of one inch should be observed on the sides, back, top and bottom to allow proper ventilation. Also a
cable bend radius of two inches should be observed for the front and top side of the unit.
DIN-Rail Mounting Instructions
Install the switch to standard 35mm DIN-Rail as shown in the diagram above.
1.
First, hook the top of the DIN-Rail clip on the back of the switch to the rail.
2.
Then, gently rotate the front of the switch downward, towards the panel.
3.
Push the bottom of the switch towards the rail until it locks into place.
4.
Apply upward force to verify the switch is securely installed.
