red lion MIL316-CCCC, Installation And Wiring Manual

Page: 3 / 17

MIL316 Hardware Manual_Rev_09-30-13.docx Page 3 of 17 Last Revised: 25-Oct-13
Red Lion Controls

20 Willow Springs Circle

York, PA 17406

USA

1-717-767-6511

support@redlion.net
Section 1 General Specifications
Overview
The Red Lion MIL316-XXXX is a 16 port industrial Ethernet managed switch designed to
meet the extreme requirements found in the toughest applications. It combines the high
performance and security of an enterprise-class switch with rugged packaging and
protected circuitry to meet the needs of the most demanding applications.
This manual will help you install and maintain these industrial Ethernet switches.
Installation of these switches is very easy and they will begin to operate as soon as they
are powered up. Though these are fully managed switches, they will act as unmanaged
until they are configured otherwise. Refer to the separate software manual or management
guide for configuration of the advanced networking functionality and security.
Note: This manual only covers the installation and wiring of these switches. Refer
to the separate Software User Manual for details on configuring and using any of
the management functions such as SNMP, RSTP, IGMP, port mirroring, etc.
Basic
Operation
Unlike an Ethernet hub that broadcasts all messages out all ports, these industrial Ethernet
switches will intelligently route Ethernet messages only out the appropriate port. The major
benefits of this are increased bandwidth and speed, reduction or elimination of message
collisions, and deterministic performance when tied with real-time systems.
These switches support 10BaseT (10 Mbps), 100BaseT (100 Mbps) and 1000BaseT (1000
Mbps) on 12 ports. Each of these ports independently and automatically senses the speed
and duplex for best performance. There are an additional 4 fiber ports (single mode or
multimode) with fixed 1000BaseT speeds. All copper Gigabit ports offer auto-crossover
and auto-polarity to assure a proper link with either straight or crossed wired cables or
even when the cable is incorrectly wired.
Performance
Specs
The switch has the following performance specifications. Note: All specifications are
subject to change. Consult factory for latest information.
ET H ER N ET P E R F O R M A N C E
 12 10/100/1000 Ethernet ports
 4 additional 10/100/1000 copper ports OR fiber ports (1000Mbps only; single mode or
multimode)

Auto-negotiation (speed/duplex) and auto-crossover on copper Gigabit ports
 Non-blocking, store and forward, wire-speed
 Switching capacity: 128 Gbps/176 Gbps
 Forwarding rate: 95.2 Mpps/130.9 Mpps
 MAC address table size: 16K
 Jumbo frame: 9K
 Ethernet isolation: 1500 Vrms 1 minute
 Connector: MIL-STD-38999 series III receptacle
ET H ER N ET C O MP L I A N C E
 IEEE 802.3 (Original Ethernet 10Mbps)
 IEEE 802.3u (Fast Ethernet 100Mbps)

IEEE 802.3z (Gigabit Ethernet 1000Mbps)
 IEEE 802.3x (Full-Duplex with Flow Control)
 Refer to product data sheet for complete list