Once assembled, the LPAX and MPAX have all the same functions and
capabilities of our PAX Series Intelligent Panel Meters. Therefore, you will find
the appropriate PAX information packed with the MPAX Module. Simply
follow the instructions to wire and program the display for your application.
TROUBLESHOOTING
For technical assistance, contact technical support.
2.0 INSTALLING THE DISPLAY
3.0 WIRING AND PROGRAMMING THE DISPLAY
LPAX DISPLAY INSTALLATION
The LPAX display is intended to be mounted into a panel or
enclosure. The display is provided with a gasket to provide a
water-tight seal. The recommended minimum panel thickness
for NEMA 4/IP65 sealing is 0.060" (1.57 mm).
For panel mounting, prepare the panel cut-out to the
dimensions shown. The supplied template may be used to
mark the cut-out and hole locations on the panel. After
the panel cut-out has been deburred, slide the panel
gasket over the rear of the display and onto the
mounting studs. Insert the display into the panel
cut-out as illustrated in Figure 3. Install six # 10-32
keps nuts (supplied) and tighten evenly for uniform
gasket compression. Do not over-tighten the nuts.
By using additional mounting accessories, the
LPAX can be surface-wall mounted, suspended, or
bottom mounted. Separate installation instructions
are provided with the mounting accessories.
Environment And Cleaning
The display should be installed in a location that
does not exceed the maximum operating temperature
and provides good air circulation. Placing the system
near devices that generate excessive heat should be
avoided.
The bezel should be cleaned only with a soft cloth
and neutral soap product. Do NOT use solvents.
Continuous exposure to direct sunlight may accelerate
the aging process of the bezel.
Figure 3, Installing The LPAX Into A Panel
ORDERING INFORMATION
* See the LPAX Accessory Bulletin or our web site for available units labels.
MODEL NO.
DESCRIPTION
PART NUMBERS
LPAXDA
5-Digit, Large Display for Analog MPAXDP Modules
LPAXDA00
Optional
Plug-In
Cards
PAXCDC
PAXCDS
Extended RS485 Serial Communications Output Card with Dual RJ11 Connector
Dual Setpoint Relay Output Card
PAXCDC1C
PAXCDS10
TYPE
RS232 Serial Communications Output Card with Terminal Block
Quad Setpoint Relay Output Card
PAXCDC20
PAXCDS20
MPAXDP
Display
Extended Modbus Communications Card with Dual RJ11 Connector
Extended RS232 Serial Communications Output Card with 9 Pin D Connector
Quad Setpoint Sinking Open Collector Output Card
PAXCDC4C
PAXCDC2C
PAXCDS30
ENC9
NEMA 4 Enclosure for LPAX
Profibus-DP Communications Card
DeviceNet Communications Card
Quad Setpoint Sourcing Open Collector Output Card
PAXCDC50
PAXCDC30
PAXCDS40
ENC90000
MB
SHR
Shroud for LPAX
PAXCDL
Analog Output Card
Modbus Communications Card
RS485 Serial Communications Output Card with Terminal Block
PAXCDL10
PAXCDC40
PAXCDC10
SHRLPAX0
Analog
Input Module
Mounting Bracket for LPAX
LX
Custom Units Label *
Listed Separately
MBLPAX00
Accessories
SFCRD2
PC Configuration Software for Windows 98, ME, 2000, XP
SFCRD200
Dual Process Input Module, AC Powered
MPAXDP00
Dual Process Input Module, DC/24 VAC Powered
MPAXDP10
