3
TYPE B
USB
ST
AT
US USB HOST
ST
AT
US
PORT B
PORT A
COMM
RT
S (PIN 6)
Tx
CTS (PIN 1)
Rx
COMM
RT
S (PIN 6)
Rx
COMM
Tx
COMM
CTS (PIN 1)
(NIC)
ETHERNET
Rx
B
Tx
A
(PIN 8)
COMM
Tx
B
TxEN
TxB (PIN 1)
Rx
A
Tx
A
AUXILIARY
ETHERNET
(NIC)
COMMS PORT
PGM PORT
COMMS PORT
RS232
RS485
RS232
DEVICE
USB
POWER
-
+
USB HOST
PORT A (PGM)
ETHERNET
RS232
RS232
PORT B
PORT A
RS485
AUXILIARY
ETHERNET
POWER
CHASSI
S
COMMO
N
+DC VO
LT
AG
E
1
2
3
CONNECTOR
[OPTIONAL]
G09 PORT PIN OUTS
CONFIGURING A G09
The G09 is configured using Crimson
®
software. Crimson is available as a
free download from Red Lion’s website. Updates to Crimson for new features
and drivers are posted on the website as they become available. By configuring
the G09 using the latest version of Crimson, you are assured that your unit has
the most up to date feature set. Crimson
®
software can configure the G09
through the RS232 PGM port, USB port, or SD.
The USB port is connected using a standard USB cable with a Type B
connector. The driver needed to use the USB port will be installed with Crimson.
The RS232 PGM port uses a programming cable made by Red Lion to
connect to the DB9 COM port of your computer. If you choose to make your own
cable, use the “G09 Port Pin Out Diagram” for wiring information.
The SD can be used to program a G09 by placing a configuration file and
firmware on the SD card. The card is then inserted into the target G09 and
powered. Refer to the Crimson literature for more information on the proper
names and locations of the files.
USB, DATA TRANSFERS FROM THE SD CARD
In order to transfer data from the SD card via the USB port, a driver must be
installed on your computer. This driver is installed with Crimson and is located
in the folder C:\Program Files\Red Lion Controls\Crimson 3.0\Device\ after
Crimson is installed. This may have already been accomplished if your G09 was
configured using the USB port.
Once the driver is installed, connect the G09 to your PC with a USB cable,
and follow “Mounting the SD” instructions in the Crimson 3 user manual.
INSERTION/REMOVAL OF THE SD CARD
Insert the SD card into the slot provided with the card oriented as shown. The
card is inserted properly when the end of the card is flush with the Graphite
case. To remove the SD card, push in slightly on the card.
WARNING - DO NOT CONNECT OR DISCONNECT CABLES
WHILE POWER IS APPLIED UNLESS AREA IS KNOWN TO BE
NON-HAZARDOUS. USB PORT IS FOR SYSTEM SET-UP AND
DIAGNOSTICS AND IS NOT INTENDED FOR PERMANENT
CONNECTION.
c
OmmunIcatIng
W
Ith
the
g09
