3/16/2020
www.reddevilsnowblowers.com | Red Devil Snow Blowers
Page | 4
Red Devil Snow Blowers is a registered trademark of Lankota Group.
Chute Installation
Figure 3
1.
Slide the chute gear ring (RED56SH
-
0007) over the top of the impeller housing chimney as shown in figure 2. The teeth should engage with the sprocket
as shown in figure 3.
2.
Place the two half moon chute gear clamps (RED56SH
-
0006) underneath the chute gear ring.
3.
Set the chute on top of the impeller housing chimney and align bolt holes of all three components as shown in figure 4.
4.
Use (8) bolts (LAN4A16A16) and (8) lock nuts (REDKRJ8) to attach chute gear, half moon clamps, and chute together to complete assembly.
5.
Grease the flange with the zerk installed on the bottom side of chimney flange. Rotate chute as you grease to ensure even grease distribution.
6.
Tighten or loosen nuts after greasing to maintain a firm grip that will rotate easily.
7.
Slide motor and gear assembly forward to make a tight fit with the chute gear and tighten bolts attaching the motor to the housing as shown in figure 5.
8.
Attach hoses labeled Chute to the hydraulic cylinder.
Figure 2
Figure 5
Figure 4
