Energy Saving Bulkhead
with PIR
Installation Instructions P.1
Red Arrow Trading
Elsworth House, Herries Road South, Sheffield,
S6 1QS
T:
0800 195 0006
F:
0870 043 3946
E:
www.redarrowtrading.com
For models: LF13PIR
Introduction
The bulkhead light incorporates a PIR (Passive Infra
Red) sensing device which continuously scans a preset
operating zone and immediately switches the lamp on
when it detects movement in that area.
This means that whenever movement is detected
within the range of the sensor the lamp will switch on
automatically to illuminate pathways, steps, patios,
porches, or whatever area you have selected to light
for reasons of safety, convenience or security.
While there is movement within range of the unit the
lamp will remain on.
Where To Fit Your Bulkhead Light
For the best results, we suggest you take into account
the following points:
•
Do not mount on a vibrational surface.
•
Ideally the Bulkhead light should be mounted 1.8
to 2.5 metres (6 to 8ft) above the area to be
scanned (refer Fig.1A).
Specification
•
Energy Saving Bulkhead with PIR
•
Wattage: Max. 60W
•
Dectection range: Approx. 110° (horizontal),
max. 10 metres
•
Supply voltage: 240V AC 50Hz
•
IP Rating: IP44
•
Material: Polycarbonate
•
Duration time: from (10±5) seconds to (4±1) minutes
adjustable
•
426 Lumen output
•
To avoid damage to unit, do not aim the sensor towards the
sun.
•
To avoid nuisance triggering, the sensor should be directed
away from heat sources such as barbecues, air-conditioners,
other outside lighting, moving cars and flue vents.
•
To avoid nuisance triggering, keep away from areas of
strong electromagnetic disturbance.
•
Do not aim towards reflective surfaces such as smooth
white walls, swimming pools, etc. The PIR Sensor scanning
specifications (approx. 12 metres at approx. 120°
horizontal) may vary slightly depending on the mounting
height and location. The detection range of the unit may
also alter with temperature change. Before selecting a place
to install your fitting you should note that movement directly
towards or away from the sensor (refer Fig 1B).
If movement is made walking directly towards or away from
the sensor and not across, the aparent detection range will be
substantially reduced. (Refer Fig. 1C).
This installation must be carried out by an electrician. Please read these instructions carefully
before installation. Leave a copy for the user/maintenance engineer for future reference.