OPENING AND CLOSING THE BACK COVER
※
Please do the following operations in a clean area with low humidity and dust.
Open & Close Dial Locks in two places, in the open position and in the closed position.
1. To open, while pressing the Open & Close Lock Button, turn the Open & Close Dial to the
right (clockwise). Due to pressurization, the back cover may be difficult to open, turn
strongly.
2. The back cover will open once the dial is turn completely to the right.
3. To close, taking care to first place the Back Cover Lip-Hing into the groove provided on the
inside of the housing body, seat back cover into place and press firmly (Note: Dial will turn
to the left (counterclockwise). While pressing the Open & Close Lock Button, turn the
Open & Close Dial completely to the left making sure the Open & Close Lock Button is
engaged (Note: If lock button is flush with dial base the lock is not engaged properly.)
※
NOTE:
Firmly press Lock Button while turning dial. Failing to do so may cause damage to
locking mechanisms.
INSTALLING CAMERA
CAUTION!
Before using, please be sure the test the housing (without camera) in a bucket of
freshwater. After use in salt water, rinse thoroughly in a bucket of fresh water without fail,
pressing all buttons several times to flush out salt deposits and other contaminants. Allowing
saltwater and contaminants to dry on housing can damage functions and O-rings. Clean with
fresh water only, using a soft, dry cloth to wipe away water.
※
Please perform proper O-RING MAINTENANCE & GREASING.
※
Please conduct the following operations in a clean area with low humidity and dust.
1. Check camera settings, battery is charged and media storage capacity is sufficient.
2. Slowly and carefully install camera making sure camera does not hit housing's internal
controls. Gently push camera forward into housing to make sure it is properly seated. If
the camera is not seated correctly, buttons, dials, and levers may not work properly.
3. After performing O-RING MAINTENANCE & GREASING, carefully attach and close Back
Cover making sure nothing is caught between the Back Cover O-ring and housing body
Contact Surface.
REMOVING CAMERA
CAUTION!
After use in water, water will remain in seams between housing body, Back Cover
and Lip-hinge Groove. Wipe any water off housing with a soft dry towel to prevent water from
falling on camera.
3.
Summary of Contents for WHR-WG50 P
Page 10: ...MEMO...
