5.
Router Table Assembly
8
9
1
Assemble the front upper brace and two upper side braces to the table legs using
M8 x 12mm coach bolts, nuts and washers, as shown below. Note position of
mounting holes for switch box on front leg. Do not fully tighten the nuts until all the
assembly has been carried out.
2
Assemble the two reinforcing struts to the rear stand legs.
3
Assemble the lower table shelf to the four legs and reinforcing struts.
4
With the table sat squarely on level ground, tighten all the screws and nuts.
5
Assemble the four pads to the underside of the table legs.
6
Locate and secure the switch box assemble to the front right hand leg.
View of table
foot fixing
Stand legs
Switch box
Lower table shelf
Reinforcing
struts
Front upper brace
Upper side brace
1. Stand Legs
2. Front upper brace
3. Upper side brace
4. Table Tilk Strunts
5. Reinforcing struts
2
1
4
3
5
Summary of Contents for RPMSR
Page 2: ......
Page 15: ...14 15 7 Parts List ...
