Documentation RM-310 C / RM-310 CT / RM-310 C Plug and Play / RM-310 CT Plug and Play
RDN 10001104
17
14.07.2020
5.4 Parameter setting level
To change the value of a selected parameter or to activate and deactivate or fade in or fade out a parame-
ter block the user must switch from the parameter selection level to the parameter setting level. To do so,
the ENTER key must be pressed until the text display switches over (for parameters locked by a code) or
the green LED "ON" begins to flash (with unblocked or previously unblocked parameters).
For parameters blocked by a code, the entry of a 4-digit code is required to release the parame-
ter (refer to section 5.5 "Code input to clear locked parameters" on this).
Subsequently, the parameter value can be changed or the parameter block activated or deactivated or
faded in and faded out by pressing the
or
key.
To save the set value or the status of the parameter block (activated / deactivated or faded in / faded out)
and return to the parameter selection level the ENTER key must be pressed until the green LED “ON”
goes out (approx. 1 second).
5.5 Code input to clear locked parameters
There are 3 different codes that are used to allow access to certain parameters to authorised persons on-
ly. In the parameter selection mode, the row 4 of the display shows what code has to be entered to re-
lease the displayed parameter (parameter code 3, 4 or 5). If nothing is displayed in the row 4, the relevant
parameter can be accessed without code. The required codes can be found in section 5.9 "Parameter list"
on page 23.
The 4-digit code must be entered as follows:
1. The code digit is selected by briefly pressing the ENTER key.
2. The digit value is set by briefly pressing the
or
key.
3. The set code is confirmed by prolonged pressing of the ENTER key.
If the code entered is wrong the message “
!Invalid input!
” appears for 2 seconds. The code input
must be repeated.
If the code entered is correct the message “
!!!! OK !!!!
” appears for 2 seconds.
All parameters that were blocked by the same code are now released for setting. The parameters are
blocked again if no key of the device is pressed for 20 minutes.
5.6 Return to the operating level
To get to the operating level the
and
keys must be pressed simultaneously until the green LED lights
(approx. 3 seconds).
