Recharge Mower PMLI-14, Safety, Assembly, Operating And Maintenance Instructions

Page: 15 / 18

15

Remove safety key from its socket.

Always store the mower in an environment where the temperature is between
–4°F (–20°C) and +104°F
(+40°C). Make sure the storage temperatures will never be outside these limits. For long-term storage, store
your battery in an environment where the temperature is lower, since the battery self-discharges slower at
low temperatures.

Store the mower in a dry environment. Do not store it on a floor that may be damp or subject to accidental
flooding. Water will damage the mower and battery.

Do not store the mower near chemicals, such as fertilizers. These products are often highly corrosive and
may cause permanent damage to your mower.

Do not store the battery in proximity to organic or other solvents.

Do not store the battery close to a source of heat, sparks or open flames.

Do not expose the battery to abnormal shaking or shocks.

Store the battery away from children and animals.

Do not press, bend or use force on the terminals of battery.

Do not apply heat (such as a soldering iron) to the terminals of battery.

Regularly observe the external appearance of the battery and keep it clean and dry. Never use a battery that
shows cracks, changes shape, leaks, or otherwise is obviously damaged.
Troubleshooting Tips
Most difficulties are easy to fix. Consult the troubleshooting table for common problems and their solutions. If you
continue to experience problems or need repairs beyond these minor adjustments, contact your local service
provider for assistance.
WARNING! ALWAYS switch off the mower, remove battery power plug from battery power socket
and remove battery before performing any adjustments, maintenance, blade change or repairs to your
mower.
Problem
Possible Cause
Corrective Action
Motor fails to
start Safety key removed from battery
power socket Put safety key into battery power socket
Safety key has been put into the
socket, but the connection is not
secure Take out safety key and put it into the socket
again to ensure the tight and secure plugging
Battery discharged Need to recharge the battery before every use,
only use a fully charged battery
Battery is defective Replace with a fully charged battery
Starting procedure is not correct Make sure you follow the correct starting
procedure:
1.Press and hold the safety button (1).
2.Squeeze the trigger bar (2) towards the handle
3.Release the safety button (1).
The blade may be blocked. Remove safety key from its socket, remove
battery, turn the mower over and check the blade.
No LED lights up
after switching
on The battery is not installed
correctly or there is a defective
LED light Reinstall the battery pack on the mower ensuring
a proper fit and connection. If you repeat this job
for more than three times, but no LED lights up,