REBOTEC /
BA-Nr.: 02.07.086/2022-05-A01
- 9 -
EN
•
Pressing (2) the lever forward breaks the 24"
wheel. Push the lever all the way down
•
If the braking effect is not sufficient or if the braking
effect decreases after some time of use, it is nec-
essary to adjust the parking brake.
Individual setting and adjustment of the
parking brake must only be carried out by
the specialist dealer. This also applies to the re-
placement or repair of a parking brake.
11.8 Height adjustment of the backrest
cushion
•
The backrest cushion is attached to the cross strut
of the backrest. It can be adjusted in two fixed
heights. By loosening the screws, the backrest
cushion can be adjusted by 80 mm.
11.9 Setting of the parking brake
•
Push the brake lever (1) all the way back. Loosen
the Allen screws (2) of the parking brake only
slightly with a spanner (SW 5). Push the parking
brake up to approx. 25 mm in front of the wheel
profile 24" and tighten the Allen screw.
•
Check the function of the parking brake by pushing
the lever forward. If the braking effect is still not
sufficient, readjust (reduce or increase the dis-
tance).
11.10 Tilt and fall protect
•
To overcome obstacles, the self-propelled unit can
be tilted backwards. This raises the front wheels
and an obstacle can thus be overcome.
•
Hold the backrest with both hands and tilt the chair
backwards until the two support legs are almost on
the floor.
•
By pulling out the clip, the tilt protect tube can be
pulled off
12 Troubleshooting
Fault
Potential cause
Remedy
Armrest can-
not be swiv-
elled down
Deposits in the
locking device
(locking bolt)
Cleaning,
checking
regularly
Locking bolt
cannot be
pulled out
Deposits, tension
spring jammed or
defective
Cleaning,
Replace
the locking
bolt
Footrest can-
not be folded
down
Deposits in the
joint,
Bracing
Cleaning,
Check
screw con-
nection
Wheel lock
does not
brake
General defect
see mainte-
nance!
1
2
1
