Radically Better Ideas®
Rebel Therapeutics, Inc. – A Delaware Corporation
Page
2
of
5
RTI FSD Quick Guide Instructions 161217
F)
ADJUSTING TENSION STRAP LENGTH: (REFER TO DIAGRAM ONE)
1.
If Tension Strap [C] is too long, then pull down at Ladder Lock Clip [O] on the short adjustment flap
end with a red marking on the edge to shorten. Pull until the Tension Strap is snug through Sock
Channel Guide [D] and up through Adjustment Clamp [F] on the other side of the Knee Assembly
[B].
2.
If Tension Strap [C] is too short, then push the tension strap up through the back of the Ladder Lock
Clip [O] until the excess loop can be pulled down by the short adjustment flap (red mark) and
continue until the Tension Strap [C] is snug through the Sock Channel Guide [D] and the Knee
Assembly [B].
G)
ADJUSTING TENSION (DORSIFLEXION) TO THE BALL OF THE FOOT: (REFER TO
DIAGRAM ONE)
1.
With the Tension Strap [C] connected, achieving the desired dorsiflexion of the foot is accomplished
by using the Adjustment Clamp [F] located on the right side of the Knee Assembly [B]. Open the
Adjustment Clamp and pull upwards on the Tension Strap [C] until the foot is dorsiflexed to the
degree desired. Use the Letter Gradient [E] to identify and mark the appropriate setting for you. Close
the Adjustment Clamp to lock the dorsiflexion setting. The tension will remain as set.
2.
For additional tension open the Adjustment Clamp [F] and pull up on the Tension Strap [C]. To
reduce tension, open the Adjustment Clamp and loosen the Tension Strap.
H)
REMOVING YOUR REBEL FOOT SLING FROM LEG: (REFER TO DIAGRAM TWO)
1.
Unclip the Tension Strap [C] from both sides of the Knee Assembly [B].
2.
Slide the Sock Assembly [A] off your foot. You can easily separate the Sock Assembly [A] from the
Tension Strap [C] by opening the Channel Guide [D].
3.
Open the Velcro support Fasteners [L and M] on top and bottom of the Knee Assembly [B] and
remove the unit from your leg.
I)
CARING FOR YOUR REBEL FOOT SLING:
1.
Store your unit where it can air-dry between uses. Avoid storing in damp locations.
2.
The Sock Assembly [A] may be washed in mild detergent. Air dry. Occasionally, the Knee Assembly
[B] may be washed with warm water. Use a laundry bag. Air dry.
3.
Do not expose your unit to sharp objects or extreme heat sources and flame.
J)
ADDITIONAL QUESTIONS:
1.
Should you have any questions, comments or concerns, refer to our website at
www.rebeltherapeutics.com
and look for the ‘Contact Us’ tab. Alternatively, email us directly at
.
2.
A Frequently Asked Questions (FAQ) Tab is also available on the
www.rebeltherapeutics.com
website, and will more than likely provide any necessary information.
