Witch v1 Rev. May22 - ASSEMBLY GUIDE
FRONT PANEL
Attach the
front panel
adjusting the parts one by one if necessary until they fit. First
Mini-jacks
then
Pots
and
DC connector.
Use the red nuts for all Outs, the smaller black nuts for the rest of the minijacks and
the larger black ones for all pots. Ensuring all of the above parts are flush with the panel.
Solder Mini-jacks, pots, dc connector and the USB Type B connector. Then connect the USB cable to the
USB A connector, this will help you to be sure that the connector is perfectly align with the hole on the
panel, solder now the connector with the cable still plugged in, remove the cable when all the pins of the
USB A are soldered. Now
press all buttons to make sure they are flat with the PCB
and all pins in their
right place (beware no bent legs!), proceed to solder them.
Adjust the
LEDs
so that they are flush with the panel and solder them.
FINISH YOUR BUILD!
Connect both PCBs together. Making sure PCBs shape and spacer fits with its hole. Then Proceed to put
in place OWL board.
Now put the yellow cardboard on the bottom of the hammond case, place the the witch, and secure it with
the screws.
ENJOY YOUR NEW
BEFACO
MODULE!
5
