Rear View Safety
Reverse With Confidence
™
8
9
BEF
ORE
YOU
B
EGIN
System Introduction
When connected to a power source the system
POWER and LINK will turn on. If both POWER
and LINK LED lights turn on, pairing will likely
be automatic.
Pair Process (if pairing is not automatic)
1. Turn on POWER to monitor (if required)
2. Press and hold down PAIR red button on
Transmitter(s) and Reciever.
3. Green Link LED Light will start blinking
4. A countodwn will start counting down to "0"
(Process takes less than a minute)
5. A "pairing failed" screen may show briefly
right before a successful pairing - disregard.
6. If system does not pair, please check wiring. Also check that LED
indicators confirm units are receiving power connection.
Note
: A "Pairing Failed" screen may display after performing a
60 second pairing synronization.
Disregard this message
.
Transmitter Diagram
Reciever
Backup Camera
(Sold Seperately)
Monitor (Sold Separately)
Transmitter
Backup Camera
(Sold Seperately)
Transmitter
Transmitter
Transmitter
)))) ((((
WIRELESS SIGNAL
LED INDICATORS
PAIR BUTTON
Wiring
Monitor or Camera(s) connect to Transmitter or Reciever through the
5-Pin Connector and recieve power from Ground Connector.
Ground Connector -
Power Source for
Transmitters / Reciever
5-Pin Connector -
To connect Transmitter
/ Reciever to Monitor or Camera(s)
LED Indicator Lights
