Install M6 Quickclip into rail tube of Foot
Platform Assembly in order to lock notched
cable in place. Install by sliding Quickclip pin
through BOTH attachment holes at the end of
rail tube. Once though, flex and fasten metal
loop onto the end of pin (as shown Above).
NEVER
remove this quick clip while this
Climber is in use. If these Quick Clips are
missing or not correctly installed,
DO NOT
use this climber.
Assembly Instructions Page 3
Use the “Roto Sleeve” to fine adjust the cable tension
on the Foot Platform Assembly . As you climb and the
tree trunk becomes more narrow, it may be necessary
to tighten the cable attachment using this “Roto Sleeve”.
9
7
8
7
Install Seat Platform Assembly onto tree ABOVE Foot Platform
Assembly by wrapping the cable around back of tree and
through rail tube“Bullet Drive System” (as shown above).
To tighten, pull on cable allowing “notched” ends to slide into the
locking “slotted” end of rail tube. Pull until the Seat Platform
Assembly is firmly locked to tree trunk.
8
9
Notched ends of
cable locking
into slotted
rail tube.
Roto Sleeve
Bullet Drive System
Distributed by Acheson Harriman Swan, LLC, 2407 W. Euclid Ave., Littleton, CO 80120
Model: RTCS-421
Deluxe Aluminum Climbing Stand
Customer Service Department 1-866-972-6168
www.primalvantage.com/realtree
©2021 (rev. 1/21)